EVO ALL Mazda CX-5 Decryptor not working

Question

I am installing a Fortin EVO ALL with THAT-MAZ1 THarness on a 2019 Mazda CX-5 PTS A/T following guide #66311. I had successfully performed steps 1-16, but repeating steps 1-12 as directed by step 17, it wouldn't complete the program, even after multiple attempts. Following previous answers in this forum, I was instructed to reset the EVO ALL and try to reprogram. Now, when I perform steps 1-12, I am getting a flashing red LED instead of the alternating Red and yellow. The Flashlink indicates Invalid Key Data. I have even attempted to program with a new module with the same flashing red LED. Any help would be greatly appreciated.

Answer 1

Hello,

Try this:

- Master reset the unit in the vehicle

- Return to the PC and re send dcryptor data

- Re attempt steps 1-12 of programming in the vehicle

 

Best regards.

Comments

Still states Invalid Key Data

---

If you re attempt steps 1-12 what does the led on the evo-all do? Flash red or go into dcryptor mode and flash yellow/red?

---

After steps 1-12 the module flashes red continuously.

---

In this case you will need to try another evo-all as the programming has not been adhered to and this unit can no longer be programmed to this vehicle.

 

May I suggest using an evo-one and a thar-one-maz3, this set up is more geared towards end consumers and the programming only involves 6 steps.

 

Best regards