Has anyone successfully installed an EVO-One on a 2019 Toyota Tundra?

Question

I installed an EVO-ONE on my 2019 Tundra Platinum and it worked for about 2 days and then lost all programming.  I am pretty sure that the module failed and have a replacement on order but has any one been successful in installing one on the 2019 Tundra?

Answer 1

Personally did many, normally the module does not fail by itself when working properly. When you will replace the module inspect the installation and make sure everything is wired properly.

Comments

Ok thanks Mathieu.  I did check all the wiring at least 3 times and there are no errors.  I just went out and tried to remote start the truck the 3rd morning and it failed miserably.  It just cranked the engine without starting and ground the starter as well.  Also none of the other functions would work.

I tried resetting the module but could never get it to clear.  Then I tried to change the program to another vehicle and then back to the Tundra and program it back to my truck but it will not recognize the CAN-BUS.  Just no luck at all in getting it to work once it failed.

---

I received a new EVO-One and after programming it, it worked fine.  The 1st module I had must have been bad.