wiring diagram and programming procedure of evo all for 2006 honda civic manual transmission

Question

installed evo all bypass for 2006 honda civic manual trans using standard keys, are the diagram the same with auto trans, when programming red lights will stay on when realising the button, press twice will blink 4x, suppose to be 10x both,  blue lights will blink rapid and not will tun off even keys was already turn to off, any suggestion, not sure if the wiring was right on the immobilizer and programming,is their was available wiring diagram for the remote starter for manual transmission

Answer 1

The only different between the auto diagram and manual would be the clutch bypass you need to perform for remote start.

 

It sounds like the bypass has programmed, was the clutch bypass done?

Comments

YES ALL THE WIRING WAS DONE, VEHCLE CAN PUT NOW ON READY MODE AND EXIT THE VEHICLE WTHOUT ANY CONCERN, LOCK THE DOOR AND AUTOMATICALLY SHUT OFF THE ENGINE, TRY TO START THE ENGINE WITH REMOTE STARTER NO SUCCESS, CHECK REMOTE STARTER TROUBLE SHOOTING ABOUT FAILED TO START, IGNITION WAS ON, IS THE BY PASS MODULE WAS NOT BYPASSING THE IGNITION SOURCE, ANY SUGGESTION,

---

VEHICLE WIRING WAS DONE, CLUTCH BYPASS WAS BEEN SET UP, TRIGGER WIRE COMING FROM GRUOND WHEN RUNNING, PIN 86 BATTERY SOURCE FROM WSITCH, I CAN PUT THE VEHICLE ON READY MODE, BUT AFTER IT SHUT OFF PROPERLY, THEN TRY TO START VEHICLE NOT STARTING, CHECK REMOTE STARTER TROUBLE SHOOTING, IGNITION WAS ACTIVE, IS THE BYPASS MODULE NOT WORKING PROPERLY OR WIRING ISSUE ON THE MODULE,

---

What type of remote starter are you using?

---

PRO START CT4211TW, ALL WIRING DIAGRAM FOR THE BYPASS AND REMOTE START FOLLOWA DN CHECK ONE BY ONE,

---

You would want to contact pro start as to why it won't start.

 

Because if it set ready mode this means the evo had tach doors and brake supplied to your remote starter.

---

YOU MEAN BRAKE OUTPUT WAS COMING FROM EVO, DOOR LOCK AND UNLOCK WAS NOT CONNECTED FROM EVO, DIRECTLY FROM STARTER MODULE,

---

Do the ready mode, STAY in the vehicle, and hold the clutch down and press the start button on your remote starter remote. If the vehicle starts, please revisit your clutch bypass connections.

If it does not, call tech support and you can be walked through testing the unit with the key in the barrel and another setting for your remote starter unit.

 

Thank you,