OEM remote does not work when engine is running (2015 Odyssey)

Question

Hi!

I connected EVO-ONE with T-harness, following instructions, including modifying the harness by cutting wire 34 and connecting it to the EVO-ONE module via green/white and green/red wires, and I also cut the white wire on the 6-pin harness.

Remote start works great, but after it's started, OEM remote does not work, so I can't kill the engine or enter into the car.

How can I start troubleshooting this?

Thank you!

Matvey

 

P.S. Instructions on your site asked for hood pin to be installed.  For this car it's not necessery (open hood acts as a door trigger and prevents remote start from activating).

Answer 1

What guide have you followed?

First page upper right hand corner will tell you the installation guide number.

Comments

Guide # 65001.  Thank you

---

Was the interrupt done on the pruple wire of the t-harness? This must be done to allow the OEm remote to work when the engine is remote started. 

---

Yes, I have cut the purple wire and connected one end to green/white and other to green/red, just like mentioned in the installation guide.

---

Can you please post a picture of the wire you cut...

---

Here are pictures of the cut harness, and where the 2 wires lead on the main plug on EVO-ONE.   I triple-checked all connections, everything matches the manual.

---

hhhmmm well all looks good there at this point I suggest calling into tech support  so we can go over further troubleshooting.

1-877-336-7797

Mon-Fri 8-6

---

Hi Derek,

I have the same issue like this, and the car shutdown when I open the door. How can I remote start and open door, hit the start button again in order to start driving ?

THank you

Serial No. 002B07273184

---

You can't. We do not offer take over on that vehicle.

---

^ that's right you can't have remote keep running after door is opened.

Does your OEM fob still work to unlock the car while it's remote started though?  Mine doesn't and I can't figure out why.