Evo-one remote starter cranks but does not start

Question

Good day all,

 

I am seeking help as I cannot figure out why when I triple press on the lock button of my remote, the car only cranks but does not start. I have verified my wiring multiple times and I cannot understand what I may have done wrong. The bypass only has option C1 activated and remote-starter is configured as can be seen on the service number page.

 

If you have any suggestions, let me know what to try!

 

Thank you!

Answer 1

You have configured the module incorrectly.

 

Turn on option A1 through A11 in the bypass side then click save.

 

Also turn off option 6 and option 38.3 in the remote starter side of the module, these are not needed.

 

Once this has been done plug it back in and re test.

Comments

Good morning Derek,

Thank you for your input, this worked! Is there any other options I can activate without causing any issue to the starter?

---

As it sits now this is how you want it configured.

 

What other options did you want to enable?

---

I am not too sure what options are available for my vehicle. I wanted to have the heated seats and heated steering wheel enabled if that's something that can be achieved.

---

That is not supported through can bus on your vehicle. It would have to be hard wired and would require an rf kit to control them.