Issue: After remote start Evo-one does not lock car.
Background: Installed Evo-one in a 2015 Subaru Legacy standard key. Only change from guide 57221 is that the Immobilizer wire was located in an alternate location on connector back of the fuse box as found on wirecolor.com for Subaru Legacy (2015-2017) photo 20. After 3x lock presses, unit will unlock and start car but will not lock after car is started. Pressing the lock button on the remote locks the car but Evo-one does not seem to sense it as there is no flash of blue light. This is also true when the unlock button is pressed. Car unlocks but no flash of the blue light on the Evo-one.
Prior to remote starting, the Evo-one blue light flashes with every press of the lock or unlock button.
Other options I have tried without success: D2 on and 6.2, D2 off and 6.2.
Other things that did not work: 37.2 causes engine shut down all the time. 7.2 does nothing. No lock or unlock.
I had double checked all the connections and all the taps are solder joints.
Turned D2 off and car remote started with 3x lock and doors stayed locked. Can use keyfob to unlock doors. Insert key, turn to on position, step on brake and key take over successful. No apparent alarm. If I use keyfob to unlock door and step on brake, engine cuts off.
So notes:
1) Prior to remote start or key start, Evo-one appears to see keyfob presses as evidence of the Evo-one blue light flashing when doors are unlocked/locked with keyfob press.
2) After remote start, Evo-one does not see keyfob presses as evidence of no blue light flashing when doors are locked/unlocked with keyfob press.
3) If car is key started, keyfob presses are not seen/ignored by the car as evidence of no lock/unlock with keyfob press and are not seen by the Evo-one as evidence by lack of blue light flases with keyfob presses.
So do we need to wire it differently, get different programming, or am I just out of luck to enable other desirable features like 37.2 and 7.2.
