What Guide do i need for 2012 Ford Fusion?

Question

ok. installing an Evo-Fort1 into a 2012 Ford Fusion.  i followed the installation guide 32171 and it indicates thru the flashing red and blue LEDs that I've programmed it correctly.  yet it does not actually start the motor during the initial push button test (just prior to the flashing LEDs).  also, when i push the lock button on the OEM remote 3x, nothing happens except i see the blue LED light up on the unit.

I did NOT buy the flash link updater nor the DCryptor module.  did NOT hook up the parking light connections (requires adding a relay), but did install a toggle switch (you call it a Valet switch) and grounded it to the frame of the dashboard.

not sure where to go from here, so any help is appreciated.

Answer 1

This is the guide you should be following: http://fortin.ca/download/32171/evo-all_ig_tsa_bi_for1-40bits_b_32171.pdf

 

If the vehicle still doesn't remote start after it gets programmed as described in the guide make sure options A1-A11 and C1 and D1 are enabled. Make sure to NOT enable option D2.

 

Also what is the service number to the module?

Comments

i will get you the number when i get access to the car (it's still connected).  as for enabling the options A1-A11, C1 and D1, how does this get done?

---

using the flash link updater.