problem with the cluster going crazy

Question

On my 2014 ram 1500 I have the evo all hooked up everything was working fine for bout a week now all of a sudden the cluster started going nuts putting on air bag light and engine light along with others that flickered now truck will not stay running with evo all plugged in I unplug unit and truck runs fine except engine light still on anyone had this problem

Answer 1

with or without a t-harness?

are t-taps being used? because it sounds like t-taps are being used.

Comments

How do I reset the module I tried doin the red light hold until yellow and red flash but I get all 3 lights in sequence

---

1. Hold down programming button while plugging in datalink connector.
2. Let go of button when LED is RED.
3. Push and hold button again until all three LEDs start to alternate.
4. Disconnect unit, she is now reset.

---

Ok did that earlier today re programed hooked up to computer decrypted the key and got the green key on computer finished setup and same prob is there any other reason y this is not working?

---

Ok, start from the beginning. This is how remote starters function.

Get out of vehicle

• Lock doors
• Remote start vehicle
• Unlock door
• Open Door
• Close Door
• Put key in barrel
• Press on brake

 

So, unless you are using the remote that the module was programmed with or you have option D3 enabled, the EVO-ALL would allow key take over.

---

Ok following those steps and it works guess I wasn't opening and closing door thanks for your help I will update if cluster goes nuts again.