Dark Blue wire Is Hooked To Door Pin Wire But Lights Still Stay on

Question

2011 nissan frontier, this truck does have auto light shutdown so i hooked the blue wire to the door pin like the instructions said. When i press lock with the headlights on auto they will try to go out but then come back on and stay on never shutdown

Answer 1

Dark blue wire need to be program to after shut down option 32 mode 4. The autolight will close about 30 seconds after the remote start shutdown. They will not close when you press lock.

You are using evoone right ?

Comments

works greart now thanks now only if i could get my ac/heater to stop blowing air when i turn off my truck. it always has power goin g to it since i installed this unit. i checkesd all my connection and it was easy to do that since i have a harness. so im lost

---

You can test this by unplugging the main harness off the Evo One, leave the red 6 pin connector plugged in the Evo One.

 

Leave the T-harness plugged in the vehicle and test,

 

If the heater fan shuts off properly with the key, verify settings in the Evo one, you post your service number here so we can see if the proper functions are enabled in the unit,

 

If the heater fan still stays on after shutting off the key, unplug the t harness and plug back the oem harness to the key cylinder. test again, if fan stays on with t-harness removed, problem is with vehicle.

 

If the problem goes away by unplugging the t-harness, I would re-plug it in and test the  orange wire on the big 6 pin main harness to see if there is 12v on that wire even with the key in the off position.

 

Let me know the results of these tests

---

service number is 002b01006776

The fan properly shuts down with the main harness uplugged and leaving the 6 pin connector

---

I just checked your service number can you please re connect the evo one to the flashlink2 updater and on the REMOTE STARTER side, please turn on function 2 to mode 3,

 

I cannot see any modes selected on function 2.

---

i still get power to my fan.

---

So with the T-harness plugged into the vehicle and the main harness of the Evo One unplugged and only the 6 pin red harness plugged in, Everything works properly?

 

If you plug in the 6 pin main harness? Does the fan come on right away?

---

yes it does so what i did was i pulled out the orange wire and wire nut it in with the oink wire then everything works. For some reason the orange wire port always has power