Flashlink setup 2017 Jeep Wrangler Manual Transmission T harness

Question

I purchased my Evo One prep with linkr from seller and adding a siren option I noticed this settings for remote start:

14 ALARM ON/OFF STARTER ON/OFF selected 14.1 (Alarm disabled. Remote starter enable) instead 14.2

31 SPECIAL APPLICATION PROGRAMMABLE OUTPUT (+) selected (Disable) instead 31.4

Is there any way to know if these settings are correct?

Thanks

Natalie

Answer 1

settings can be verified with the modules S/N number

Comments

Do I need to email you that information privately (I will need your email address).. or can I send it via comment?

Thanks for your support

---

Here is the S/N 002B04 043387

Can someone help me to choose the right option please?

Thank you :)

---

Following up ...

Can someone guide me here?.. should I change the settings made by the seller that prep my Evo One setup?

 S/N 002B04043387

Thanks in advance

 

---

If you want remote start and alarm, option 14.2 is not enabled alarm and remote start.

I do not see option 31.4 enabled. This would give a (+) parking light output on the WHITE wire.

 

For the RF protocol, there is no way for us to know if the reseller enabled the proper protocol for the LinkR.

---

The prep was the Evo One with the T harness

---

If you want remote start and alarm, option 14.2 is not enabled alarm and remote start.

I do not see option 31.4 enabled. This would give a (+) parking light output on the WHITE wire.

 

For the RF protocol, there is no way for us to know if the reseller enabled the proper protocol for the LinkR.

---

So enable 14.2 and 31.4 will be the setting I should change?. Thanks in advance

---

yes, correct