2012 Ford Fusion SEL - Cannot get Remote Start to Work

Question

Building further onto my previous question:

I have completed the EVO programming with the dcryptor and it says it successfully programs.  I am using the latest firmware and software.  When I plug the EVO back into the vehicle and prss the lock button x3 it will not start the vehicle.  I can see on the EVO the blue lights flash when I hit the lock buttons, but that is all it does.  I have the options set in the module for 3x lock to start it.  I made sure the CANBUS wires were making contact and tight.  I tried to reprogam again last evening and still not starting.

Any thoughts on how to get this to remote start my 2012 Fusion?

Answer 1

Your option 3x lock is not enabled. You must enable D1.10

Comments

Thanks

I will try that as soon as I can get it back onto the computer

Answer 2

Also make sure you reprogram the 2 functional keys each time you remove the module. I ran into the same problem when programming my wifes 2012 ford fusion.

Comments

Is the dcryptor step required on the 2012? Trying to do one now and the first key i get red and yellow light 2nd i only get red and after removing the key and pressing the button nothing happens aside from the security light flashes

---

Nevermind... figured out that my can splice was not good. Threw the scotch locks away and did it right and all is good now