Rockford fosgate autolink and EVO-ONE

Question

I have the EVO-ONE installed and working on my 2018 Tundra, I just bough a Rockford Fosgate Autolink followed the instructions and changed the settings on configuration/unit options on the remote starter side with the flash link updater to H2.

now when I tried to pair the autolink to the EVO-ONE, the instructions call for turn key to ON, yellow light on EVO-ONE comes on, but when I press the button on the EVO ONE nothing happens, red light does not come on or flash it does nothing. I can get the autolink to pair with the EVO-ONE.

FYI, datalink protocol is set to F2 on my unit, do I need to change another setting? thanks in advance for your quick reply.

Dan

Answer 1

If you are refering to F2 this means you have enabled the protocol in the wrong side of the module (bypass mode).

 

You are going to need to reset the module, re program the module and re configure the correct options.

 

I would suggest calling in so we can walk you through this.

 

1-877-336-7797.

Comments

Did you get this to work? I was told the Evo-one should work out of the box.....looks like they are saying to make some program settings. I have the Evo-one working good and program the Autolink but it won't start the Tundra. Will locl care, show battery voltage and cell signal.

---

Did you follow all steps in this guide?

 

http://cdn02.fortin.ca/download/64631/autolink-install-guide-64631.pdf