Questions & Answers

Does the black foot break wire have to be conected to the green brown foot break on a 2015 ram 1500 tip key

+1 vote
ALL OTHER CONECTIONS AR COMPLETED  BUT WHEN I GET TO STEP 5 PUT THE KEY IN  THE LIGHT STAYS YELLOW IS THER SOMTHING IM MISSING
posté Nov 17, 2016 dans la catégorie Ram par david billingsley (220 points)

1 Réponse

0 votes
Are you using a t-harness ? Sounds like the module is not seeing the vehicle immobilizer data. Verify your light blue/black wire.
répondu Nov 17, 2016 par david billingsley (85,210 points)
Yes im using the T harness the light blue  and the light blue and black are conected  to the t harness from the 20 pin conector i also checked the can high grey to grey and white and can low grey and black to yellow  also conected ignition yellow to ignition pink and light green  also cut black and red wires on  black data link conection and  conected lt blue to the purple  door pin but it still stays yellow when i put key in  what should i have in the program turned on and off

Is this ok now? If i look at the service number it shows up that you finished programming the unit. Unless the unit was previously used before; in this case, a master reset is needed.

 

http://fortin.ca/en/support/001a06656971/

Yes works great thanks so much I loaded software on laptop instead of main computer and flashed from the then it worked not sure why but as long as it worked I'm happy
...