Fortin Evo One red and yellow flashing

Question

I have a evo one and using a t-harness for my 2015 Subaru WRX Limited Manual transmission. I go the wires all hooked and Im not sure if I was able to get the initial programing done correctly. I was doing this at work and needed to get home despite being unsure of it being programed properly, started my car and drove home. I tried doing the initial setup with the red and blue light being solid. Now the module has a solid blue while blinking red and yellow at the same time. Is this a concern ? What should I do if it's not correctly setup.

Answer 1

it will flash yellow and red if you did not finish the dcryptor programming sequence, it is flashing that way to tell you to go to the computer and do the dcryptor process.

 

Thank you

Comments

Thank you for your reply,

So I have to use the flash link to finish?

---

Yes your vehicle requires the flashlink.

Answer 2

what is the service number to the module?

Comments

Thank you for your reply:

Service No: 002B07 133071

---

Looking at the service number provided this module is set up for a Nissan 370Z.

I would connect the module to the flash link, select your year, make and model.

Flash the proper firmware for the vehicle.

The do the programming in the vehicle from start to finish as shown in the installation guide.

---

So i was able to flash it and install the module. When turned off no lights blink. When turned on it blinks the yellow light. is this the correct setup?