Questions & Answers

Evo all not flashing blue when turn key to on position

0 votes
2014 tip key Grand Caravan. Using Evo all (no tharness ) and titan ts1;2 remote starter. Not in data mode.

Successfully programmed my fobs

Successfully programmed Evo all with flash link

However when I go to learn the vehicle to the Evo all, as soon as I turn the key to the o. Position (with the blue light currently solid) it turns the light off. It will not blink

 

Any help would be appreciated! TYIA
posté Juil 18, 2015 dans la catégorie Dodge par Donnie Maxwell (210 points)

1 Réponse

+1 vote
 
Meilleure réponse
Verify your can high and can low connection.
répondu Juil 18, 2015 par Donnie Maxwell (85,210 points)
élue Juil 20, 2015 par Donnie Maxwell
Thanks turns out my high was a bad connection. Could you also lead me to where I would find a tach wire behind the dash for this vehicle
The EVO-ALL outputs tach on the pink wire from the 20-pin and also through datalink if using datalink.

If you would rather connect directly to the vehicle, the only signal is at any of the injectors. It's the non common colored wire.
thanks. i have verified all my connections and verified my tach connection yet im still getting the 7 flashes from the Titan ts-142 which indicates tach or tach lockout. ive tried running the vehicle to remove that tach lockout with no success

Did you run through the tach learning procedure given by Titan?

(copy-paste from their guide)

TACH LEARNING THE TACH WIRE MUST BE CONNECTED TO A GOOD TACH SOURCE

a. Start the vehicle with the key.
b. Press footbrake and hold down.
c. Within 10 seconds, press and release the valet switch then then press and hold it for at least 2 seconds. The unit will enter Tach Learning Mode.
d. If a viable tach signal is detected then it is put in memory and learning is confirmed by 2 park light flashes and two horn/siren/horn (optional) chirps.
e. If no Tach signal is detected, the parking light will flash and the siren/horn will chirp 3 times.

...