No parking lights

Question

I installed the EVO-ALL with the CHRT5 on a 2006 Chrysler 300C and everything work well---EXCEPT the parking lights do not come on when I remote start. I connected the the wht/brn wire in the headlamp switch harness including a 2.4K ohm resistor.

I leave my lights in auto mode and I wonder if that could be the issue.

Answer 1

You can try switching your switch to the OFF position to see if that solve the issue.

Comments

It works with the switch in the off position but I only use the auto position. There has to be a way to activate the lights at another point so the switch position is not relevant I would think.

---

Try with 1670 ohms. If it still does not work, you may need to relay isolate the connection.

---

I'll try that. Can you share how to isolate the connection with a relay?

---

Cut the vehicles white/brown parking light wire.

• Pin 85 : (-)trigger from evo
• Pin 86 : Fused 12V (about 5 amp)
• Pin 87a : to connector side of cut white/brown wire
• Pin 30 : to vehicle side of cut white/brown wire
• Pin 87 : to the resitor, then resistor to ground.

---

I tried isolating the connection as instructed but no change in functionality. I can hear the relay activating (clicking). I picked up the 12V at the 12V+ at the ignition switch where the evo is plugged in (I assume that's OK).