Questions & Answers

Programmed Evo All for 3x lock Start .Will start but shutsdown after a couple seconds

0 votes
2011 Town and Country
posté Dec 27, 2014 dans la catégorie Chrysler par Frederick McWilliams (160 points)

1 Réponse

0 votes
Can you provide the service number written on module ?
répondu Dec 27, 2014 par Frederick McWilliams (85,210 points)
Edited Question with service #
Make sure you connected yellow wire coming from t-harness to yellow wire on the 20 pin connector of the evoall.
Yes that was done
is the yellow wire showing 12v when ignition is on and 0v when ignition is off ?
Do I need to reprogram unit in car after updating
Yes it does show 12v on and 0v when off
Master reset and reprogram

Hold button, insert 4 pin connector, release on RED led, press again program button and hold until leds start to alternate then release. This is master reset procedure, now disconnect 4 pin and reprogram your module.
Will I need to reupdate it with FlashLink or just in vehicle
works. just whent thru in vehicle programming
...