Questions & Answers

Clutch bypass 2014 Jeep wrangler.

+1 vote
Hi  I am using the neg when running  to bypass my clutch wire but it s not going to zero volt like the OEM switch does. Can I use   On 6 pin red connector from Evo All , the white/ blue and  white / red wire  One to ground and other to cluch switch as my   clutch bypass ?

 

Thanks , Marc.
posté Nov 10, 2014 dans la catégorie Jeep par Marc Voyer (920 points)

1 Réponse

+2 votes
 
Meilleure réponse
A wire also need to be cut at clutch switch http://image-1.wirecolor.com/vehiclegroupimage/69231.jpg . If you want to use evoall relay, white/red is 30, white/blue is 87, white/green is 87a
répondu Nov 10, 2014 par Marc Voyer (85,210 points)
élue Nov 10, 2014 par Marc Voyer
Good  thanks , I was hoping to use evo relay.  I m a lazy guy ...
hi, so just to confirm a few things on this setup (sorry to bring back an old topic)

instead of using a relay, I can use the EvoAll and use the connections you mentioned above?

if so, what happens with the 12V and GWR connections required on the relay? i suspect that is managed with the EVO All?

I ask because the issue i am having with my 2014 manual jeep is when i release the clutch, i get a red light on the evo-all module and i have to reset it every time, i suspect this is due to the clutch bypass not in place?
...