Hello installed Evo-All SN:001A07 583704 stand alone and alarm mode in G2 everything works, in G3 no horn chirps Thanks!

Question

When G2 is turned off and G3 is turned on everything works but no horn chirps on lock and unlock

Answer 1

I'm sure they can access this info, but year, make, model, standard key or push to start is good starting info

Are you using a T-harness also?

Comments

NO T-Harness, your t-harness does not fit...Wire to Wire, 2019 GMC Savana 2500 Standard Key Stand alone, Alarm mode is on, horn already wired in, when G2 is on, alarm works. panic works and horn chirps work but horn chirps on every press. When G3 is turned on everything works but no horn chirps.  Also this vehicle does not support B1 if that's related. Thanks!

Answer 2

Did you wire the horn in?

Here is the generic alarm guide to show which wire becomes a horn output when G is enabled.

https://cdn02.fortin.ca/download/16221/EVO-ALARME_20200221_16221.pdf

Comments

Yes, you already provided me with that diagram and it was very helpful thank you!

---

Are you using an RF-KIT or OEM remote? Horn chirp confirmations from the OEM remote is not available to prevent double/triple honking on vehicles that would naturally honk on lock/unlock from it's oem remote.

---

Fortin RM442   RF Kit

---

Option G3 makes it silent though,

Turn on G2.

---

Do you mean to turn on G3 and G2 at the same time or do you mean that G3 is not an option that will work for me, I was hoping that there was a way to use G3 so that there was a horn chirp on the second press.  Thank You

---

Enable both G2 and G3

 

With G2 OFF, horn confirmations are simply off.
G3 makes it so the second press will confirm.

---

Thank you,  I will give it a try and let you know!