Questions & Answers

EVO ALL not powering up

0 votes
I orginally installed this and had power, but it wasnt functioning correctly so I disconnected it till I could find the answers to the problem. I now plug in the EVO All while holding the button and get no power to the EVO ALL. I used the THAR-VW6 and TB-VW on my 2011 VW TIguan. When I plug it into theFlash link I get a single red light on the EVO ALL and both the red and green on the flashlink. Also when I try to Process the Data throught he Flashlink, i get ' INvalid Key Data".
posté Aout 6, 2023 dans la catégorie Volkswagen par Keith Bliss (160 points)

1 Réponse

0 votes
No power in the vehicle can ba caused by incorrect connection to the vehicle, please verify that the correct connector is being used and is plugged into the correct connector at the clockspring module. Also please pose the SN so we can verify the correct FW has been flashed.
répondu Aout 7, 2023 par J M (64,060 points)
So I undid all of the wiring and started back at factory on the car. The original issue still persisted and I found a blown 5amp fuse under the hood. I replaced it, verified the car worked. I reinstalled all wires according to the directions. The EVO All is still not powering up. SN 001A07 283508.
you are using connector A and not B from the vw6 harness?
Yes, Connector "A".
I am using the Connector A from the VW6 Harness.
...