2018 lexus rx350 evo all stand alone

Question

need some help with a 2018 rx350 i installed a evo all stand alone and hard wired everything, it programs fine but does not start, the evo all doesnt flash when i press lock but if i turn igntion on it lights up yellow. i tried different firmwares and still same thing, i also double checked all wires if anyone knows the issue let me know

thanks

 

i plugged in a evo one i had and programmed it to 3x lock and it started, so is it possible the evo all is defective?

Answer 1

Possible, what is the service number to the evo-all, I'll take alook at the settings for the module.

Comments

001a07061538

thanks

---

D2 is on. It should be off

Also, on all toyota/lexus push models, RESET and reprogramme when it does not take on the first go.

---

hey quick question the evo all i posted before i ended up using it in a another  car and it worked so i went and got a new evo all but that one when i plug in the data wire it lights up red and stays red, it doesnt cycle to blue, red / blue , yellow , does that mean its locked?

sn: 001A07 067208

---

i tried doing a master reset but it stays red

---

module is bugged. To unbug.

 

1. flash version 0.99
2. disconnect unit from the flasher and power cycle it in the car (connect/disconnect black connector)
3. reconnect it to flash link and flash whatever firmware you need
4. Turn settings protection off if it's on 
5. Reset the unit

 

---

ok thanks it worked everything is good. one last question, i installed a evo start with it and everything is working fine, except the trunk does not open do i have to change a setting on the evo al?

---

This Q&A is not the best at tracking replies...

 

Trunk is a hardwired connection.  On the EVO-ALL, for that car, there is no programmed output for trunk release.