EVO ALL Options for 2016 Nissan Roque Push Start

Question

What are the options should I choose when installing an EVO ALL for 2016 Nissan Roque Push Start.? 

Service No: 001A06 546107

Thanks

Answer 1

Stand alone or with a remote starter?

Comments

Stand alone

---

First thing looking at your service number something happened to the evo. I would suggest a master reset as shown here: http://wirecolor.com/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193

The options needed are listed in the guide as well.  for stand alone turn on C1 and D1.

Once this is done program the module in the vehicle.

---

Thanks. I did a master reset the module but it did not flash anternate. just solid red. But it did a big difference, I can see what is off and on. What else is to be turned on?

I might do the installation by next week.

Thanks again Derek

---

Master Reset will not work if you are trying to do it on the flash link. Unless..... you either use a datalink cable that only has the power and ground wires, or TOGGLE to Connection Mode: Remote Starter just for the reset. (remember to toggle back to bypass afterwards, must toggle while unit is disconnected)

-------------------------------------

If we look at your service number here: http://fortin.ca/en/support/001A06546107/

All the A options should be ON  (A1 - A11)

C1 should be ON

D1 should be ON

D6 should be ON