2016 nissan versa, can't find a guide for a non transponder key.

Question

Evo one, thar-nis5 kit.

Answer 1

If the vehicle has no transponder, you would not connect the 4 pin transponder connector. Then you would follow just the blue led programming a shown below: 

Comments

I followed those steps but when I turn the key off it flash red and yellow back and forth

---

Reset the unit first then connect the module to the flash link and turn OFF option A3-Key Bypass. Then reprogram following the steps Derelk provided. 

 

To reset.. 

1. Hold down programming button while plugging in datalink connector.
2. Let go of button when LED is RED.
3. Push and hold button again until all three LEDs start to alternate.
4. Disconnect unit

---

Good try Derek, but the last step, after yellow an red start to flash. The Decrypto option dont appear. This is wasted time, guide Sentra Sedan 2012 - 2018 Standart Key Sedan, doesnt work.

---

Master reset the evo (https://cdn.fortin.ca/en/download/61931/61931.pdf), turn off A3 in the options of the unit, re do can only programming. It wont switch to yellow red anymore.

---

First of all, please always start your own thread instead of replying to an old one,  Secondly, it would be pointless to.run dcryptor on a non immobilizer nissan vehicle. As mentioned 2x in this thread, A3 needs to be disabled as to force the module to not try to do dcryptor Thirdly, does the Nissan Sentra you mentioned not have an immobilizer system?

---

1 Jesus Monroy, you do not have to give an opinion where you have not been asked anything. Have more professional ethics!

2 There are suggestions to check before opening a new thread and since this was an unresolved issue I decided to continue it to avoid wasting time for other installers. There is no point in opening a new thread if there is an unfinished one.

 

PS: Thank you very much Derek for your answer. Kind regards.