Tilt, shock and proximity on Evo-All

Question

Hello, i have to connect these sensors to my evo-all. can u tell me which wires i have to choose as inputs? I have to use diodes on the trigger wires sensors ? only one diode is enough ? or one diode for every sensor that share the same input? Thanks

 

I have dei sensors (504d 507 508) Thanks,

Answer 1

This is the evo-all alarm guide, it shows you what each wire will do and which wires are used for sensor inputs. 

https://fortin.ca/en/download/16221/16221.pdf

Comments

Thx for answer, i will connect the dual stage proximity sensor and shock sensor to a3 wire, and tilt sensor to a2 wire, i have to use diodes on the a3 wire?

---

Yes, diode isolate is a good idea.