2016 Ford F150 doesn't display run time after vehicle starts.

Question

A network error comes in after a minute or so, but the vehicle is running ?

Answer 1

Need more details....products used, service number etc...

Comments

I have EVOALL module with Linkr LT1  S/N : DCGKOL-4000363148

I can get service number later if needed. Thanks !!!

---

Yes, its needed.

---

Service # 003606 015357

 

The error message that I get is this...

The request returned an invalid code. Please check your network connection and try again.

I get this message, but the truck does take the start command.

---

What protocol did you set the app up in?

---

ADS Protocol

---

You should have set it up in fortin according to step 7B of the installation guide:  http://fortin.ca/download/64631/omega-linkr-lt1-install-guide-64631.pdf

---

Got it... how do I change the protocol from the app ? Or do I need to reset the device and start over to put in the Fortin protocol ? Thanks !

---

STEP 7. PRE-CONFIGURE MYCAR APPLICATION EXPERIENCE FOR YOUR CUSTOMER

 

a. Click on the vehicle to enter the control screen (the screen that will allow you to control the vehicles’s remote start functions). This will automatically take you to the “Vehicle Configuration” page for this vehicle. You will be prompt to “Set a Bypass Protocol” to use this device. Click “Ok”.

b. Now you must set the protocol for the MyCar device. When combined with the Evo-All remote starter previously installed, you must set the protocol to “Fortin” and click “ACCEPT”.

 

c. Then from the top of the Settings section edit the Vehicle name, configure the Auxiliaries that might have been added if applicable and click ACCEPT when done. Then choose the vehicle to display in the control panel in the VEHICLE IMAGE section and click ACCEPT once done.

 

d. When yourconfigurations are all completed, click “Done” at the top right corner. All Configurations will take effect.

 

e. Now please allow a moment for the MyCar device to update your protocol selection and be available to accept commands from the App. In the vehicle control screen, the Device Signal icon located above the Stop button will display the connectivity status of your MyCar device. If the icon is Grayed out, Please wait, Device is still Offline. If icon is Green, Device is Online and Ready to go.

---

I cannot change the protocol from ADS to Fortin ???