Jeep does everything but start

Question

Hooked everything up and get the unit to program to my key.  Following all the directions, it seems that I have done everything correctly.  When I hit lock 3 times, all the doors unlock then lock and the dash lights up like a Christmas tree.  I hear all of the relays clicking and the headlights turn on but the Jeep fails to start.  The red and yellow LED light up and the blue LED flashes but doesn’t start.  It appears on the dash lights that the alarm is still armed.  Once I put the key on the ignition and turn to the on/run position, it starts up on its own.

Guessing that the unit is not disabling the immobilized.  Please advise...the unit was pre-programmed and shouldn’t have needed the flash link.

Firmware is 74.32

Answer 1

Make sure the green/red from the evo-all 20-pin is not connected to anything. As per diagram, it should not be connected to anything on specifically the Wrangler.

If someone "pre flashed and setup the unit" you should also give them a call.

Comments

Only wire from the 20 pin connector that is hooked up is the yellow wire leading to the t-harness.