Français

Questions & Answers

Vehicle doesnt shut off unless the lock 3x is used or timer runs out. 07 ford edge

I followed the install instructions and programmed with two keys, and the it'll start, but I either have to way until the timer runs down or hit lock 3x. 2007 ford edge with evo all standalone.

closed with the note: brake status not detected on can-bus

asked Oct 29, 2017 in Ford by kyle skonieczny (180 points)
closed Oct 30, 2017 by derek g

1 Answer

Best answer

What is the service number to the module?

answered Oct 30, 2017 by derek g (340,410 points)
selected Oct 30, 2017 by derek g

service number is 001a06 725931

commented Oct 30, 2017 by kyle skonieczny (180 points)

also on the options settings through the flashlink, i have a1-a11 and c1 and d1 turned on

commented Oct 30, 2017 by kyle skonieczny (180 points)

With the key on in the vehicle, meter the black wire on the evo-all and tell me if it outputs voltage when apply the brake pedal.

commented Oct 30, 2017 by derek g (340,410 points)

the black wire is on the 20 pin connector and not hooked up to anything right?

commented Oct 30, 2017 by kyle skonieczny (180 points)

correct.

commented Oct 30, 2017 by derek g (340,410 points)

there is no voltage on or off the brake pedal.

commented Oct 30, 2017 by kyle skonieczny (180 points)

hhhmmmm this means brake is not present on can bus, were was can high and lo connected?

commented Oct 30, 2017 by derek g (340,410 points)

Yes the can high and low are hooked up.

commented Oct 30, 2017 by kyle skonieczny (180 points)

to what pin numbers?

commented Oct 30, 2017 by derek g (340,410 points)

can high is to pin 3 on the DLC connector and can low is connected to pin 11 on the DLC

commented Oct 30, 2017 by kyle skonieczny (180 points)

For some reason brake is not present on can on your vehicle. I suggest calling tech support for futher troubleshooting.

1-877-336-7797

commented Oct 30, 2017 by derek g (340,410 points)

So per my phone call, to wire in a relay, I would need to wire 87 to dark blue wire, 86 to 12v out of brake pedal and 85 to ground and 30 to ground. Does that sound correct?

commented Oct 30, 2017 by kyle skonieczny (180 points)

Here you go

commented Oct 31, 2017 by derek g (340,410 points)

thank you for your help

commented Oct 31, 2017 by kyle skonieczny (180 points)

...