Installing EVO-ONE in 2017 Kia Sedona US model w/push to start. It will not crank.

Question

Here are my steps for install. I've flashed the module for Kia ver. 76.36. Programmed options c1 in bypass mode for oem remote monitoring, set function 38 to mode 2 for 3x oem start in remote start mode and cut the yellow loop wire. In vehicle I plugged in the 6-pin main connector while holding the programming button, released button on solid red, plugged in remaining connectors, pressed program button 7 times and got 6 red flashed, pressed push to start button twice, got 10 fast red flashes, then blue flashing. Turned vehicle off, closed all doors and pushed oem remote lock three times. I get confirmation beeps three times and blue led on module flashes with each push of the button, but the module does not power up (no red led) nor does the vehicle power up and crank. I did not wire the parking lights because the install guide #58421 for my vehicle shows pin a18 (green/red) for parking lights but the quick install guide #32991 that came with the modules shows pin a12 for parking lights. This may be because one is relay controlled and the other is can bus controlled. I'm not sure.

Any help with this is appreciated.

Answer 1

Is the module perhaps in valet mode?

Was the yellow loop cut before power up?

Comments

Thanks for replying Derek. Yes, I did cut the loop before power up.

Answer 2

You must connect green/red A18 to the wire shown in the install guide.

When the remote start refuse to start, it gives you a parking light flash flash that will tell you why it didn't start. Count the flash.

Comments

Thanks for replying Mathieu. I've just connected the green/red wire as directed. I'm still getting no module power up and no blinking parking lights