How to add RF-2WT10-SS to evo-gm3 with FT-D100 RF decoder

Question

How to add RF-2WT10-SS to evo-gm3 with FT-D100 RF. wihch wire do i plug from the eve-gm3 in to the FT-D100 in the sucket with plugs side byside with 2 pin and 4 pin or 4 pin and 6 pin  they are same plugs on evo-gm3 and the compustar.

Thanks 

 

Answer 1

Here is the installation guide you would need to follow for that RF kit.

 

http://cdn.fortin.ca/download/20141/edge-2x-rf-ar2wt10-ss-install-guide-20141.pdf

Comments

With the compustar rf kit there is a ADS Data cable do i need it for the evo-gm3 and FT-D100 ?

---

Yes make sure you swap Rx and Tx on the end that will plug into the evo-all as shown in the guide linked above.

---

Ok i will..

Thank you.

---

it not the pulg that go's in to the FT-D100 it the plug that gos in to the evo-all that i have to change then. there are 3 pulg one that is for evo-one and one for evo-all and one for adding rf kits and antenna

---

swap both side or one side?

Answer 2

it work?