PROGRAMMING 2013 F250 STANDALONE

Question

Installing a THAR-FOR1 Tharness; Evoall Stand alone installation.

When programming, I go from 1-7 with no issue. When I get to step 8, I do not get the LED's to flash. In turn, The Key will not start the truck manually unless i diconnect the D2D connector.

I have the MADE THE T-HARNESS CONNECTIONS:

                A1/RS6 YELLOW/BLACK----------->YELLOW (IGNITION +)

                A20  LT. BLUE--------------------------> LT. BLUE

                A10 LT. BLU/BLACK------------------> LT.BLUE/BLACK

CAN HIGH ---> GRAY C3

CAN LOW ---> GRAY/BLACK C4

I followed the troubleshooting guide, with no resolve. Any other suggestions?

Answer 1

When you cycle through the keys after turning key 1 on for the second time do the door locks cycle?

Also service nubmer to the module please?

Comments

Try going through the programming from the start but do not connect the red connector to the evo.

Also do you have access to the flash link updater2?

---

Does not seem to program with leaving the red disconnector off.

I will order a flash link updater 2 and reload the firmware. The vendor I bought this from said he loaded it for me for the make and model of vehicle.

Is there anything i should look at ?

---

only other thing i could see is a poor/weak connection.

If butt connectors or t-taps were used anywhere remove them and make a proper poke and twist connection.

---

flash link Updater showing module updated to 71.28 at this time.

---

Please test with a digital voltmeter if voltage is present on the yellow wire (Pin A1) on the 20 pin connector WHEN the oem key is INSERTED (just inserted, not turned to IGN) and DOES NOT drop out when turning the key to the ON/RUN position, if it does, this is the issue you are having, it is not uncommon even on new trucks to have an intermittent key sense wire, for normal starting it does not matter, but to be able to program our unit, the yellow wire needs to see voltage the second the oem key is inserted and turned to IGN.

(red connector does not need to be connected for programming)

 

Thank you,