Evo ALL with Ford THarness 2012 Ford Fusion

Question

I have hooked up all connections except for driver door pin because I can't seem to find the correct wire. When I hold the program button and plug in the black 4 pin connector to start programming, nothing happens. No lights come on or anything. When I plug it back in to the Flashlink it comes on and shows the info. Am I missing something? I have my only vehicle dissasembled and really need to get this done. PLEASE HELP

Update: I checked the red and black wires on the black 4 pin plug and there is 12.5 volts at the connection. Is this a bad unit?

Update part 2: I flashed with an older version of firmware and then reflashed back to current/recommended firmware and it finally cooperated! Up and running. I do have one final question though, I did not hook up the left door pin wires because I couldn't find the correct one to use. What functions will I not have because of this? I have noticed that the car will only turn off if I press the brake. Any ideas?? Sory for the long post, just trying to do it right. Thanks!

Answer 1

If the driver door pin is not hooked up you will not get any RAP control.

To turn the car off press the brake or press lock-unlock-lock again.

Comments

What is RAP control?  I also have not connected the driver door pin and the remote start works, but the alarm goes off about 1 in 5 times.  I have the following options ENABLED:

• A1-A11 (EXCEPT A5 as listed in the installation guide)
• C1
• D1+D1.6
• D2
• D3
• D4