evo-one can't program

Question

HELLO, STILL NO LUCK TO CHEV AVEO 2008, ALL WIRING IS OK AND ALL THE PROGRAMMING SEQUENCE IS OK BUT STILL DOESN'T PROGRAM,WHEN I TURN ON TO RUN POSITION THE RED AND YELLOW ON, NO RED FLASHING,CAN ANY ONE PLEASE HELP,ITS EMBARASSING TO THE CUSTOMER,IVE BEEN TRYING EVERYTHING AND STILL NO LUCK,ITS ONLY 3 WIRE ACCORDING TO THE INSTALL GUIDE AND STILL NOT WORKING...PLEASE HELP....

Answer 1

Make sure when you are in programming mode (RED led on) that you press a total of 3 times on the programming button. Then make sure the LED is flashing twice every couple seconds before turning the ignition ON.

Comments

hello,yes its blinking twice everything is normal according to the sequence but when i turn on to run position the yellow and red turn on solid then nothing happen...

Answer 2

Flash it back to the default 4.18 firmware. MAster reset and program the unit.

Comments

hi robert, did you mean after i flash to 4.18 program it again to the recomended firmware?

thanks

---

dont use the updated the firmware. Flash the unit to 4.18 firmware and program it to the vehicle with that firmware.

---

hi robert,

Good day to you! ill try this weekend,i already flash it to 4.18 firmware,will see what gonna happen....

Thanks

---

HI ROBERT,

MERVIN, THE EVO ONE FOR 2008 AVEO IS NOW WORKING,I PROGRAM TO 4.18 FIRMWARE AND ITS WORK! THANKS FOR THE HELP AND I APPRICIATE IT...AGAIN THANKS A LOT!..