What Key Data wire to connect.

Question

Good day,

Im using the guide no. 58411 for Hyundai Santa Fe 2013 key start. Can you help me with the wire D6-White/Red? Wire D4-White/Green will be connect at the same time with A10-Lt.Blue/Black to Key Data-Blue wire. Im just confuse with the "cut" symbol? Really appreciate the help. Thank you.

Regards,

Arlo

Answer 1

Cut the wire in half. You will then be left with 2 ends.

One goes to the connector and the other end of the wire goes into the harness.

Connect accordingly as shown in the installation guide from this point on.

Comments

Thank you for the reply derek. Now im confused :) i have D6-white/red & D4-white/green wires. What wire should i cut in half and connect to Key Data? Thank you.

---

Cut the blue key data wire in the vehicle.

On the side going to the vehicles connector you will connect the lt.blue/black and white/green.

on the side of the wire going into the wiring harness you will connect the white/red.

---

Ok now i got it Derek. Its now 9pm here in Dubai. i will try it early morning tomorrow and reply to you what will happen, good or bad. Thank you.

---

Last one Derek, after i connect the Key Data wires, should i repeat the all the programmings? thanks.

---

If the key data wire was not connected properly during the initial programming then yes I would suggest reprogramming the module from start to finish.

---

Thank you. i will reply the outcome tomorrow.