Flash programed the EVOALL and now it won't program in the car

Question

I flashed the evo to the recommended firmware and now I cannot reprogram in the vehicle. It will only enter into the learn mode. Will not turn the yellow LED on when I turn the key to the run position. I even purchased a second EVOALL and flashed it and get the same results.

Answer 1

Make sure you have connected the yellow accessory wire from the EVOALL 20 pin connector to the BROWN accessory wire of the vehicle. You can also test this wire with a DMM, it should should 0v when key is off or key is at start, and 12V when key is on accessory or ignition position.

Answer 2

Use firmware 70.18