Blue led's flash 3x when remote pushed but no start,could the dycripter be wrong?

Question

Blue led's flash 3x when remote pushed 3x but no start,could the dycripter be wrong? Also if I reflash the Bypass side to a different version do I need to run the dycripter again?

Answer 1

Yes you will have to redo dcryptor once it is flashed.

Looking at the service number the firmware is too low for your vehicle. Guide states 71.27 and up and you have 71.18...i'd suggest re flashing the bypass with at least the minimum or higher and re do the programming start to finish.

Comments

try this for me....

turn the ignition on, press the valet button 3 times, then turn the ignition off and try and remote start the car...

---

With the key in the ignition in the on position yellow LED lights up, pressed valet button 3x removed key and tried remote start and get the blinking blue LEDS and nothing happens.

---

is the red led underneath the yellow loop on when the vehicle is at rest? try the same sequence again key on 3 times on valet button key off and remote start the vehicle....just want to be sure it isnt in valet mode as this would prevent the vehicle from starting....

---

The red light is not on. Tried it again and it still not starting.

---

Rico and have it working now, that's pretty much what we did. Also one of the settings was on tachless changed that. All seems fine now, the car starts with the remote. This 4 day marathon install  has come to a end.