Questions on Install 2015 Dodge Charger PTS

Question

I'm pretty confused on the install for my 2015 charger

 

1.  do i need to tap into the can high/can low?

2.  if i'm not using the parking lights,  or alarm,  do i need to tap into the 12v ignition,  door pin and parking lights?

Answer 1

1.  do i need to tap into the can high/can low?

- YES

2.  if i'm not using the parking lights,  or alarm,  do i need to tap into the 12v ignition,  door pin and parking lights?

-No For parking lights and door pin optional connections. (door pin is for rap control). YES the yellow wire must be connected to a igntiion wire in the vehicle.

Comments

the instructions mention a resitor,  and a diod,  but i don't see them on the wire diagram

 

Also,  do i need to connect parts of the tharness to the other side,  the wiring diagram kinda shos the ltblu and ltblck piggy backed to each other?

---

What are you installing in the vehicle.

How are you installing it?

---

evo one with the chrt6 t harness,  standalone,  no other modules

---

The necessary connections for remote start are:

 

1.Yellow (A1) 20 pin connector to IGN wire in the passenger kick panel.

2 Can High and Can Low (C3 and C4) to the proper wires on the obd2 connector.

3. Lt. Blue/Black (A10) 20 pin connector to Lt. Blue/Black of the t-harness.

4. Lt. Blue (A20) 20 pin connector to the Lt. Blue of the t-harness.

 

Thank you.

---

if i do do the door pin,  and the parking lights,  do i need any relays,  or diods?

---

no green/red is used for parking lights and is connected as shown in the guide.

The door pin is negative trigger so no relay needed their either.

Test before connecting is my suggestion to prevent permanent damage to the module.