2008 ford edge doesn't start after successfully completing all programing steps

Question

please help me I installed evo all with T harness, i did all connections as the diagram then i did all programming  steps in a correct manner and got the last conformation x10 red egnition started the flashing blue light but the egnition didn't start by pressing x3 lock button in oem remote!! i got one blue flash lights with each lock press

i called the technical support they said hit the yellow/black wire from 20pins on the ground for 2 seconds i did that and got just one blue flash and nothing happened

by the way my evo all was flashed with the last update and activated with all options

Answer 1

All your options seem fine but we can only see the options from the last time it was connected to the flash-link and the options tab was opened. If a master reset was done at any point afterwards, the options went back to default.

If the dark blue wire on the 20-pin is grounded, it will prevent remote start. So make sure it's not connected anywhere.

Comments

I didn't do reset but could you explain how to do that master reset?

the dark blue not connected

---

Master reset can be found here: https://fortin.ca/en/qa/50193/faq-how-do-i-reset-my-evo-all

I do not recommend a reset though if you do not have the flash link since this will reset all the options back to default.

 

The yellow/black test is actually a little tricky. It works two ways, a single 0.5 seconds pulse to start and then to stop or just ground the yellow/black and leave it grounded. Leaving it 2 seconds may actually just be starting then stopping it automatically since it falls under the 2nd mode.

---

was a solution ever found?