mazda 3 2013 push to start evo-one

Question

installed a evo-one in a 2013 mazda 3 with a push to start, Rene Bourassa told me to install it like the evo-all so i did. after the installation vehicule didnt start, managed to make it start but the remote keyless entry light comes on has well as about 4-6 dtc codes. the customer had a system previously installed from an other company with same trouble. system doesnt seem to be able to bypass RKE system

Answer 1

Question, were you re-using the same wiring the previous system was connected to? The module may still program correctly if the Tx or Rx connection is no good (i forget which).

Comments

keep me updated about it if you found out how to do it so i can do it for my customer

tks

---

Ok, the start-stop connection will definitly be on the White/Black wire of the EVO-ONE and not the Pink/Black. We will be finalizing the new firmware tomorrow and adding some improvements.

A firmware reflash will be necessary.

---

Firmware 0.47 and using the White/Black for the start-stop connection will get this up and running. The installation guide is being owrked on today and should be available by either the end of the day of tomorrow so it's up to you if you wish to wait on the EVO-ONE.

 

I would suggest a master reset to the EVO-ONE after flashing to the 0.47 firmware.

---

any plan on putting the installation quide online

---

trying a E400 with i-datalink on an manual of same year still same trouble arise when trying to start gives me a 6 flash code (crank time over 8 sec)but car doesnt crank at all then all lights stay on in car

tryied with auxiliary key in ignition still doesnt crank

manage to make it start but only start on the second try ACC doesnt come on first try then comes on on the second and it start