Unable to program EVO-ALL to Volvo S60

Question

Installed EVO-ALL into 2005 Volvo S60, begin programming - blue LED on, once i put key in ignition, Light goes out.  turn the key to acc, and light stays out.  light comes back on when key is taken out of ignition.

Answer 1

what is the 12 digit service nunmber of the EVO? (if you still have it)

It's acting like if it's not detecting the Can-Bus. This may be fiirmware related or connections.
 

I'd recommend trying a Master Reset on the EVO:

1- Hold down programming button while plugging in datalink connector.
2- Let go of button when LED is RED.
3- Push and hold button again until all three LEDs start to alternate.
4- Disconnect unit, she is now reset.

Comments

Service # is 001A06 221229

---

Try that master reset and re-attempt programming. If it does the same thing, you will want to look at the Can-Hi and Can-Lo connections.

---

Have tried the master reset and re-programming with no success.  Re-checked Can-Hi and Can-Lo, both are good connections.  Tried moving can hi and lo from DLC to harness in drivers kick.  still nothing.  Re-checked all connections, everything looks to be ok.  My main power is in drivers kick panel at red wire, starter is yellow/white at ignition, accessory purple at ignition, ignition blue/red at ignition.  key sense is from EVO-ALL to yellow wire at ignition.  The remote starter is an Autostart AS-1780.

---

Try firmwares:

77.06, 4.18 and 4.06. Tell us what happens when trying each one.

---

I have the same exact issue with an 06 .any idea what it could be?

---

I tried updating to 4.18 but that didn't change anything.

---

Were you ever successful in getting your Evo-All and remote starter to work ?  If so I'd like to talk to you about it ...