2010 dodge challenger im using evoall and lcpro 4 remote start wont work

Question

i have it sucessfully programmed. the doors loc/unck but wont remote start HELP

Answer 1

You need to activate the last option for crimestopper, might also need to enable OEM remote stand alone remote starter.

Comments

And how do i go about doing this?

---

how do i do that?

---

What happens when your try to remote start the vehicle using the crimestopper remote? What LEDs are turning on on the EVO-ALL?

 
If parking lights are connected to your crimestopper remote starter, they will flash X amount of times representing an error code. In the crimestopper user guides / install guides, it will tell you what X amount of flashes means.

---

i did no additional wiring. just the T harness and programmed it. when i attemept the remote start function i hear 3 clicks from the lc but nothing happens, reall didnt pat attention to the lights

---

Do you have a Flashlink-2 updater?

 

If so, you can easily test this system, by programming the Evo-All into Stand-Alone mode (option C1 and D1 to ON) and try to start it using the OEM keyfob 3xlock or by pulsing the YELLOW / BLACK wire on the 20 pin connector of the Evo-ALL to ground.

 

Then once you have it running on standalone mode, then you can test if the crimestopper and Evo All are communicating.