The FOB that came with my EVO-ONE will not program?

Question

The unit is detected by the vehicle and the valet button make the parking lights flash but when I hit the  (-) button then the lock button like the instructions say it never programs.

Answer 1

Did you press/release the brake before doing (-)+lock ?

Also, what is the 12 digit servive number and which remotes are they? it says on the sticker of the remote. service number is on the evo-one

Comments

Yes I did the brake press/release. I followed each step by step multiple times. And yes it is the FOBs that came with the evo.

---

and which model remotes is it (sticker on remote has model number)? What is the 12 digit service number of the EVO-ONE?

---

EVO number is 002B01007443 remote model is FTX44-2W

---

I don't see any firmware loaded... odd... http://fortin.ca/en/support/002b01007443/

Is that the correct service number?

Reflash the remote starter side to 1.15

---

After flashing the mouse turns into the loading signal and stays that. but it does say that the update went through. Is that normal?

---

yes that number was correct it says that it is at 1.15 when i plug it in.

---

yes, we force that the unit be disconnected after a flash

---

at the step that says push / release brake. use the analog foot brake input instead. So jump the input to 12V then remove it. Maybe it's not detecting foot brake through can-bus.

---

Will try that and get back to you thanks Robert

---

call tech support if you still can't get it to work so that you don't have to wait on replies from me over here lol

1-877-336-7797