Help With Evo-All Programming Trouble Shooting

Question

I'm working with a 2005 Chrysler Sebring Convertible & I purchased a Fortin Evo-All. I am installing a Avital 4103 Remote Starter in the vehicle. I followed all the proper wiring procedures from the Fortin site & performed a W2W . When it can to the programming I held the program button while plugging in the power harness & released on blue. After releasing on blue I plugged in all other connectors. According to Fortin's site I put the key in & turn it to the ON position & within 1 min the bypass will alternate between colors. However, when I turn the key to the ON position the blue led shuts off & 5-10 mins later no other LEDS has lit up. When I shut the ignition off the blue light comes back on. There is no remote start, no horn, no locks.

Answer 1

Hello,

 

From what you are describing: "Let go on blue LED, turn ignition On, blue LED turns off ", this means the EVO is not detecting the vehicles databus. Their can only be 2 reasons for this to happen

1. Firmware 4.06 is required for this vehicle. The EVO comes preloaded with 4.18 (if you purchased it new). You are required to downgrade the firmware to 4.06.
2. The data J1850 connection is faulty.