R35 GT-R 2015 push to start only lights turn and no engine start ! I have EVO -NIST1 !

Question

Hello

We have problems installing EVO-NIST1 on a Nissan GTR 2015 and we have followed what fortin said on the instructions and it dont work and also the the instructions fortin has for finding out whats wrong but i dont work as it should !

Between this 2 instructions there is different diagrams with the 2 instructions and that do not make it easier and when plugging in the box should the button be push down or not ?

When programing folloving the lights and the instructions the lights jumps over steps !?

What flash should be used standalone or the other one !?

when pushing the button 3 times only lights but no engine start it never even try to start !?

When disconecting the box every thing works normal.

EVO-ALL number SN: 001A07 535353

Can any one help us in any way to sort this out !

Answer 1

Hello,

What guide did you follow, first page, upper right hand corner will have the guide number, please provide it.

Also along with plugging in th et-harness, what else did you connect?

Did the module program as inidcated in the installation guide? If it missed steps, which ones was it?

 

Also your module is set up wrong, Options A1 through A11 should be on.

 

Best regards.

Comments

shall I have D2 on also?

after i -Once reset re enable options C1, D1, D1.10 and D6.

all the steps 1 to 9 in the Guide 84611 be successful

but the blue led dont flash when i press lock, it flash when i press unlock.

-You can confirm stand alone functionality of the evo through pulsing the yellow/black wire as previously mentioned.

if i just grund the wire and have the key in the car the car light turn on but the engine dont start

I changed to 72.48 but it did not be any change from the 72.54

what is Guide 84611 the split in puple/yeallow cable to LT.blur/black for? do i need this split in?

i dont have the aftermarket hood pin connected A8

---

- D2 is not needed.

- If the vehicle does no start verify brake light operation, We start this vehicle the same way a person would, the evo presses the brake pedal, then presses the pts button and sends key codes.

- yes purple/yellow is supposed to be connected to lt.blue/black.

---

okay good!

it still doesn't light up when i press the lock button on the ome remote only when i press the unlock button

---

As previously stated. If c1 is on and the blue led does not blink when pressing lock on the oem remote after the unit has been succesfully programmed to the vehicle, the only other alternative at this point would be an RF kit.

---

Ok can i use my OEM key if i get one ?

with RF kit should i get ?