Key fobs wont program

Question

I have a 2006 Chev silverado 2500HD and i have installed the fortin EVO ONE. I can get the module to program once all the wires were hooked up under the dash but i cannot get the RF942 antenna to light up when trying to program the key fobs. is like it is not detecting it. i have tried both methods with the valet switch and cycling the key and foot brake 4 times. The only time i get a flicker from the antenna is just when you plug it in. This was pre programmed from the shop i bought it from and they dont have uch insight for me. Is it possibly a programming issue? I have gone through all my connections several times and they are all good on that end.

Thanks

Answer 1

Hello,

If you disconnect the 20 pin connector from the evo one are you able to then get into programming?

If so you would wanna check your brake wire or parking light wire if it was connected.

If that still does not work then please try the following:

1- flash the remote starter with firmware 0.99

2- plug the main 6 pin connector into the evo for 1 minute.

3- return to the pc and re load firmware 1.26

4- re attempt remote pairing.

Best regards.

Comments

I did. It worked, Thanks