Evo-All will not program

Question

I have a 2006 Dodge Ram. I hooked up the evo-all with the t harness and made the 4 connections at the ignition switch, I have triple checked all the connections they are hooked up to the correct wires and have verified that they are getting connection but when I start to program the module I hold down the button while pluging in the data connector and stop on the blue light, I then connect the other connectors but when I do the next step which is turning the key on the blue light goes out, when i turn the key back off the blue light comes back on. I have used the flash link and verified that everything is set up correctly and has the latest firmware. I think this is the step that is supposed to be programming thru the can bus, Any ideas would be very helpful

Answer 1

How many seconds did you wait after turning the key to the ON position?

Comments

At one point I just left it on and walked away for 10 min and still nothing

Answer 2

Had a very similar with a 2012 Dodge Caravan - hooked up, key on lights off...

It needed (re)programed, once I reprogrammed it, the flashing lights were as depicted in instructions.

For the programing, perhaps try again. Follow the prompts on screen and click "flash" it will take a couple minutes to complete the Linkupdater and Module will both flicker lights and a progress bar should be displayed.

Answer 3

First, need to confirm the module has proper firmware. What is the service number of the unit? 

 

Second, I have seen a handful of "older" jeep/dodge that the CAN network is running on single CAN versus dual CAN. Pointing to an issue on the car itself. To know if there is an issue you need to meter each CAN wire independently. 

From the 5 pin white connector. Each need to metered (Vdc) with ignition ON. 

• CAN HIGH - GREY
• CAN LOW - GREY/BLACK

Comments

I actually just tried today reflashed it to 4.09 just to see if it changed anything which it did not. Service number is 001A07391297