My EVO ALL unit never reachs to step-6- of the programming steps in FORTIN guide #97611

Question

I connected my evo all unit according to the wiring diagram that I already downloaded from the website, then when I started the programming procedure, also according to the steps in the guide #97611, everything was going on normally until step-5-, then the unit never move to step-6- ( after I press and release programming button (in step-5-) the blue LED goes off and never return back flashing). I repeated the procedure one more time but I reached the same step and the unit never moves to the next step.

My unit SN:001A07 283796

Answer 1

Hello,

 

The module is flashed for a 2020 chevrolet equinox push to start, however guide 97611 is for a dodge journey...

What is your vehicle?

 

Best regards.

Comments

My car is dodge Journey 2020 se

---

Hello,

 

Please set the module up accordingly, it is not set up for the right vehicle.

 

Best regards.

---

Thanks for your quick response, but how can I set it for the right vehicle?

---

I have installed flash manager on my PC and connected the evo all via flashlink-lite updater, but can not communicate with the evo all unit

---

Please contact reseller support 

sales@lesscoelectronics.com

 

---

Hi, please is it ok to connect the CAN high and CAN low wires of the evo unit to the CANs wires of the OBD II interface?