2015 VW Golf Evo-One Manual Trans, TB-VW THAR-VW6, No Start, Ready Mode Error

Question

I have a 2015 VW Golf.

Installed and programmed Evo-One with TB-VW, and THAR-VW6.

I run the car, and am able to enter ready mode by pressing brake, pulling handbrake, then releasing brake, and pressing start on the fob.  The car responds, and I am able to remove they key.  I get out and close the door, and the car seems to go into ready mode giving one flash of the parking lights.

When I send the remote start command with the fob, the car starts the procedure and then gives me 3 flashes before even trying to crank.

Is it possible there are any settings in the evo-one that may be causing the vehicle to lose ready mode before it starts.

Thanks

Answer 1

Is this your module? 002B04211217

 

All options and setup look ok.

Is the PINK E5 wire receiving ignition with the key on?

Did you add a hood switch ?

Comments

Hi Robert,

Thanks for the quick reply.  

I do not add a hood pin installed as the A15 pink/black wire is connected via the THAR-VW6, and that wiring guide doesnt show a hood pin installed. A11 is currently turned off.

E5 is receiving voltage with the key on.

I also tested E1, and it received voltage on takeover when I remove the key, and sends voltage when trying to start.

The car doesn't crank when trying to remote start.

---

Also forgot to mention yes that is the module installed in the car.

---

I just found another post indicating if A11 is off it will ignore the hood status on CAN-BUS.  I tried the system with it set to on, as I thought perhaps the THAR-VW6 was using the CAN-BUS, but unfortunately it still did not start.

I did notice when going through the start sequence I get a ligting error on the dash about the time I would expect the system to crank.  Not sure if that has anything to do with the issue or if it is expected behaviour.

---

Just wanted to advise I reflashed the evo-one and reprogrammed it.  The remote start now functions.  Not sure what caused the issue earlier.