Evo one 2008 mkz regular install, need to know where to hook alarm

Question

Need to know where to hook up my duel shock , and siren on evo one wire to wire. Guide 88581 also going to use compustar 901 remote. I believe I only have to swap the rx/tx wire.

Answer 1

Here is the alarm guide: https://fortin.ca/en/download/16221/16221.pdf

 

Purple/White is the shock sensor input.

Comments

This guide is for evo all. I'm using the evo one. Thx

---

On an evo-one you would plug it into the 3 pin shock sensor port on the side of the unit. You would then enable option 14 in the rs side of the module to activate the alarm.

---

Then where am I hooking the siren on the evo one ?

---

Siren would be the orange/black after you confdigure option 12.

 

https://fortin.ca/download/33021/rf642w-install-guide-33021.pdf

---

Ok option 12 what... for the orange/blk wire ? What all options are needed to be selected. Now on this duel shock sensor do I tie both trigger wires together and run to center pin of 3 way plug.. is that a multiplex input. Because I would like pre warn also. Then for my 3rd question where shall I tie in my tilt sensor. I would like it seperate in case I want to disable it. Thx derek.

---

Also option 12.4 is negative trigger. Is this what I need. Why not the white main wire for accessory2 since it's not being utilized in this car. Then what about the harness main output. Option 2 ?

---

You can use orange/black or the large white wire on the main 6 pin connector if it is not used in the installation.

 

Option 12 in the remote starter is how you configure what wire youll be using and how it will react.