I have ignition, but won’t start 20 wrangler

Question

2020 Jeep Wrangler manual transmission. I (think) have everything programmed, but when I do the 3x lock all I get is ignition. I can hear the fuel pump kick in but the starter doesn't hit. I get the factory red led blinking in the dash and the lights flash three times. The evo module responds with the blue led like it's supposed to while I am pressing the lock button, but nothing after that. No red and yellow as the troubleshooting guide suggests. I don't know what to try next.

Answer 1

Assuming that the clutch wiring was correctly done.

3 flashes indicates ready mode not active. Manual transmission vehicles require that the user set Ready Mode in order to allow the vehice to remote start.

Enable option 33.2 in the evo and look at option 3 in this guide on how to set ready mode: https://fortin.ca/en/download/87611/87611.pdf