EVO-START2 Installation with EVO-ONE on Mitsubishi Outlander: Which connection model?

Question

Car is a 2016 Mitsubishi Outlander GT 3.0 PTS.

Everything was installed as per the instructions (EVO-ONE) and the software was updated as reccomended. The OEM key turns on the car without any problems.

When adding the EVO-START2, I realized that the BLACK 4-PIN CONNECTOR was not included with the EVO-START2 packaging. Before ordering the proper cable, I was wondering which connection (1. high powered, 2. low powered RF2A, 3. low powered with THarness) model I need to do with my car (as per the EVO-START2 installation guide).

I searched and saw that you don't sell a Mitsubishi Outlander THarness of any kind... so connections 1 and 3 seems out of the question, but I wanted to double check before ordering the RFA2A connector for connection 2.

Answer 1

With the evo one you simply plug in to blue connector from the antenna cable into the small blue port on the evo-one. No adapater or power connections ndeeded.

 

Connect the loose yellow wire to igniiton

 

Then program the antenna to the module as shown in the guide below.

 

http://fortin.ca/download/69731/evo-start2-ant-install-guide-69731.pdf